DHOLLANDIA hydraulic ramps are developed and manufactured using state-of-the-art technology, high quality materials and components and highly skilled workmanship. They comply with the European CE safety regulations mentioned in the Declaration of Conformity issued with each lift (unless agreed otherwise for hydraulic ramps exported outside of CE region). The DH-AR* series comprises of a range of hydraulic ramps, designed for a wide variety of trucks, trailers and semi-trailers, and is available with lift capacities ranging from 3,000 to 20,000 kg.

PLATFORM

  • Reinforced full-width steel platform, manufactured from closed steel sheet
  • AR…1: longer, articulated steel platform over the full vehicle width
  • AR…2: longer, articulated steel platform in 2 separate sections with open space between
  • Mechanical support legs under the articulations between the 2 platform halves

FUNCTIONAL & MECHANICAL CHARACTERISTICS

  • Universally useable, compact frame (carrying the platform and the cylinders) to be fitted at the rear of the vehicle chassis
  • 100% load capacity for loads on min. 4 wheels, 75% load capacity for loads on max. 3 wheels [see options]
  • Synchronised opening and closing of the 2 articulated platform sections

HYDRAULICAL CHARACTERISTICS

  • 2 double acting tilt cylinders (open-with-motor) [OAH026]
  • 2 stabilisers between the platform point and the bottom platform section result in synchronized opening and closing of the 2 platform halves
  • Electrical safety valves on all cylinders
  • Manual emergency operation on all electrovalves
  • Cylinder piston rods in hard-chromed stainless steel
  • Cylinder(s) equipped with rubber gaitors
  • Robust pump unit 12V or 24V DC, supplied loose for mounting on the vehicle chassis

ELECTRICAL CHARACTERISTICS

  • Exterior control box with main battery disconnect switch and removable key
  • Electrical controls without sensitive electronic components
  • Safe exterior controls with compulsory 2-hand operation
  • Electric motor with thermal cut-out fuse

FITTING

  • The frame is usually welded to the rear cross member of the loading floor and the vehicle chassis

FINISH & MAINTENANCE

  • Low-maintenance bearings in all articulation points, plus grease nipples

HYDRAULICAL CHARACTERISTICS

  • 2 double acting tilt cylinders (open-with-motor) [OAH026]
  • 2 stabilisers between the platform point and the bottom platform section result in synchronized opening and closing of the 2 platform halves
  • Electrical safety valves on all cylinders
  • Manual emergency operation on all electrovalves
  • Cylinder piston rods in hard-chromed stainless steel
  • Cylinder(s) equipped with rubber gaitors
  • Robust pump unit 12V or 24V DC, supplied loose for mounting on the vehicle chassis
Open chat
1
Scan the code
Hello 👋
Can we help you?